|
Chatroom |
|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
| Register | FAQ | Members List | Calendar | Mark Forums Read |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
12-July-2006, 07:50 PM
|
|||
|
|||
my motorized 300mm dobson
I have motorized my 300mm dobson whit steper motor.It is not finished yet.Now, I would like to make goto or autoguider sistem.How to..............Thanks for help
|
|
12-July-2006, 08:55 PM
|
||||
|
||||
|
I'm not for sure, but I think auto-guide system's have to connected to motors made specifically for the software.
__________________
Life is full of choices. Sometimes you make the good ones, and sometimes you have to kill all the witnesses.
Lurker - "This is baut... we can't decide on the safety of pbj sandwiches in less than 9 pages..."
|
|
13-July-2006, 01:52 AM
|
|||
|
|||
|
Hi Andrej,
You will find EVERYTHING you need here : http://www.bbastrodesigns.com/cot/cot.html I motorized my 10" dobson, using Mel's software and it works fine :-) Good luck with your work, your scope looks impressive :-) Bojan Last edited by Bojan; 13-July-2006 at 07:19 AM..
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
